What are the common causes of route flapping in a RIP network?

RIP, EIGRP and OSPF are all interior gateway protocols (IGP) while BGP is an exterior gateway protocol (EGP). Basically, interior protocols are meant to ... RIP is a distance vector (DV) routing protocol, using UDP packets for exchanging information through port 520. RIP uses a hop count to measure the distance to ... Distance vector routing protocols (e.g., RIP) have been widely used on the Internet, and are being adapted to emerging wireless ad hoc networks. However, it is ... General Configuration . set protocols rip network . This command enables RIP and sets the RIP enable interface by NETWORK. Routing Information Protocol (RIP) is used to manage router information in a self-contained network, such as a corporate LAN or a private WAN. With RIP, a ... Subsequently, the modeling of both OSPF and RIP routing protocols within a SONET DCN network was created. The overall results show that a pure OSPF protocol ... Routing Information Protocol. Routing Information Protocol (RIP) is an Interior Gateway Protocol (IGP) designed to manage a relatively small network. RIP is ... RIP is a distance-vector simple interior gateway protocol suited to small-sized networks. It employs UDP to exchange route information through port 520. RIP is an interior gateway protocol (IGP) that uses a distance-vector algorithm to determine the best route to a destination, using the hop count as the metric. OSPF[6]: CARP demote. OSPF[6]: Influence interface cost based on CARP status. Dynamic Routing Protocols. RIP (Routing Information Protocol) - legacy. OSPF ...

Find similar items here:

what is rip routing protocol

• Is RIPv1 a classful routing protocol?
• What factors might necessitate adjusting RIP timer values? How does RIP handle routes learned from multiple sources (e.g., different RIP routers)?
• What are the implications of using RIP in a CIDR environment? What is manual summarization in RIP?
• How does RIP work? What is the maximum hop count in RIP?
• What are the use cases for selectively enabling RIP updates on passive interfaces? What is the default behavior of RIP regarding advertising directly connected networks?
• Why might a path with fewer hops not always be the best path?
• What is load balancing in the context of RIP?
• How do you verify the enabled features on a Cisco router? What are the historical roots of the RIP protocol?
• When is a route advertised with a metric of 16?
• How do you configure RIP version?