How do I enable IPv6 on my router?

Can a INTERFACE like fa0/1 have a layer 3 IP address and then I create a subinterfaces say fa0/1.1 and put an IP address on them as well with DOT1Q....should ... Something in the 10.xxx network other than 10.0.0.xxx. Much less likely there will be a customer network using that scheme. A router should not influence it ... If this is not a mulit NIC issue you're facinf, the IP address should be discovered and changed automatically. ... What if you set the new IP address using ... Aug 17, 2007 ... ... IP) and I know the WAN IP address and the gateway address. I think that I should use the IP address, but my question is. If I put this IP in ... Customers should also avoid sending traffic directly to these IP addresses and instead use your configured termination Fully Qualified Domain Name (FQDN). Each subnetwork could potentially support up to 30 host addresses. This brings up an interesting point. The more host bits you use for a subnet mask, the more ... Jan 24, 2019 ... Which IP address should I use for IPSec tunnel monitoring ... Hello,. I made an IPSec Tunnel with Fortinet device, and it has some issue. So I ... They could then use a phishing attack to try and convince the ISP to turn over whatever PII it has on you. One sure way to prevent identity theft is to buy one ... Under Properties, look for your IP address listed next to IPv4 address. Set ... You should use this in most cases. Your PC will be hidden from other ... Jul 9, 2016 ... Using a FQDN instead of an IP address means that, if you were to migrate your service to a server with a different IP address, you would be able ...